Vertical Turbine Drainage Pump

Product Category

Vertical turbine pump

Product Code

LP(T)

Product Overview

LP(T) long-axis vertical drainage pump is mainly used for pumping sewage or wastewater with non-corrosiveness, temperature lower than 60 degrees and suspended matter (without fiber and abrasive particles) content less than 150mg/L; LP(T) type long-axis vertical drainage pump is based on LP type long-axis vertical drainage pump, and the shaft protecting sleeve is added. Lubricating water is introduced into the casing. It can pump sewage or wastewater with a temperature lower than 60 degrees and containing certain solid particles (such as iron filings, fine sand, pulverized coal, etc.); LP(T) long-axis vertical drainage pump can be widely used in municipal engineering, metallurgical steel, mining, chemical papermaking, tap water, power plant and farmland water conservancy projects.

/vertical-turbine-drainage-pump/
LP-2
LP1
LP

Product Features

The motor drives the impeller working under the liquid to rotate through the shaft. After the fluid gains energy through the impeller, it changes direction through the guide fluid, flows vertically upward along the flow channel between the riser pipes, passes through the water outlet seat, and is ejected horizontally.

Performance Range

1. Flow range: 8-60000 m³/h
2. Head range: 3-150 m
3. Power: 1.5KW-3600KW

Working Conditions

1). The medium temperature should not exceed 60℃.
2). The medium must be neutral, and the PH value is in the range of 6.5-8.5. When the medium does not meet the requirements, it must be indicated when ordering.
3). The content of suspended solids in LP pump medium must be less than 150 mg/L; The maximum diameter of solid particles contained in LPT pump medium must be less than 2mm, and the content must be less than 2g/L.
4). LPT pump must be externally connected with clean water or soapy water to lubricate rubber bearings, and the pressure of lubricating water should not be lower than the working pressure of the pump.
5). At the lowest water level, the first stage impeller of the pump must be submerged for more than 0.5m, and generally (2-3)m is appropriate.
6). When ordering, the depth of the well or the submerged depth of the pump shall be indicated.
7). Special conditions of use shall be subject to the contract or technical agreement.

Main Application

LP(T) long-axis vertical drainage pump can be widely used in municipal engineering, metallurgical steel, mining, chemical papermaking, tap water, power plant and farmland water conservancy projects.

Structural Installation Instructions

1. The inlet of LP(T) pump is vertical downward, and the outlet is horizontal. The discharge port of the pump can be above or below the foundation.
2. The impeller of the pump is divided into two forms: closed type and semi-open type. Impeller blades are divided into non-adjustable, half-adjustable and full-adjustable. The impeller of the pump is completely immersed in the pumped liquid, and there is no need to pour water when starting. 
3. LP(T) pump is based on LP pump, which adds shaft sleeve and adopts wear-resistant materials, which expands the application range of the pump.
4. The impeller shaft is connected with the transmission shaft and the motor shaft by coupling nuts. 
5. The bearing adopts water-lubricated rubber bearing, and the shaft seal adopts packing seal.
6. Generally, the standard Y series three-phase asynchronous motor is used as the motor, and YLB type special three-phase asynchronous motor can be used according to customer's requirements. When Y type motor is equipped, the pump is equipped with anti-reverse device, which can effectively prevent reverse rotation.